Item |
Description |
Quantity |
Unit |
Rate(Tk) |
Amount(Tk) |
01 |
Dismatling Brck Wall - 125mm Thick
|
50.00 |
M2 |
55.00 |
2,750.00 |
02 |
Dismantle and removal of ground floor door and windows with frames , clamps embeded in brick walls , ensuring no breakage of glass and minimal damage to wooden frames . Dismant
ling to be done with appropriate scaffolding. Adequate covering and protection to be provided against weather conditions and insects, required contineously until completion of door and window replacement. Removal of rubbish to assigned dump, cleanup of the work area, as per instruction of EIC.
|
45.00 |
M2 |
40.00 |
1,800.00 |
03 |
125 mm thick ordinary brick work (1:4) including supplying and carrying of bricks, sorting and soaking of bricks (Min 24 hours), curing (Minimum 10 days). Bricks to be soaked for 24 hours in two stages of 12 hours. Fresh water to be used for each stage of soaking. All complete as per drawing and direction of the Engineer-In-Charge. |
400.00 |
M2 |
360.00 |
144,000.00 |
04 |
250 mm or more thick ordinary brick work (1:5) including supplying of coarse sand, bricks, sorting and soaking of bricks (minimum 24 hours with fresh water), curing for min 10 days all complete as per direction of the EIC . |
30.00 |
M3 |
2585.00 |
77,550.00 |
05 |
Average 20 mm thick cement plaster (1:6) to wall maintaining sharp angle at corners, joints, kobla etc. with steel trowel finish including supplying of best quality coarse sand, screening, curing for minimum 10 days all complete as per dorection of the E.I.C. |
1000.00 |
M2 |
86.00 |
86,000.00 |
06 |
Minimum 8 mm thick cement plaster (1:4) to all R.c.c surface such as ceiling, coloum, beam, lintel etc maintaining sharp angle at corners, joints, kobla etc. with steel trowel finish including supplying of best quality coarse sand, screening, curing for minimum 10 days all complete as per dorection of the E.I.C. |
400.00 |
M2 |
74.00 |
29,600.00 |
07A |
Reinforced cement concrete work(1:1.5:3) in all R.c.c works having minimum crushing strength 25 Mpa (cylinder) at 28 days with Holcim Cement, 20mm down graded stone chips, sand (F.M.not less than 2.5 ) including washing, breaking of chips, screening of sand, mixing, laying, compacting, maintaining levels, curing for minimum 28 days etc. all complete as per direction of the EIC.
Column |
4.00 |
M3 |
6800.00 |
27,200.00 |
07B |
Floor Beam and Lintel |
33.00 |
M3 |
6800.00 |
224,400.00 |
07D |
b) Floor Slab, False Slab |
30.00 |
M3 |
6100.00 |
183,000.00 |
08 |
Supplying and fabrication of deformed bar of Grade 60 with minimum Fy=415 Mpa of different sizes and length in all R.C.C works including straightening, cutting, bending, binding, making of chairs and placing of spacers with supply of G.I wire(22 BWG) and welding, placing in positing where specific, hooking, cranking. lapping etc. all complete as per drawing, specification and direction of the Engineer M.S. Road (fy=415 Mpa) |
12.00 |
TON |
30000.00 |
360,000.00 |
09 |
Plastic painting of best quality & approved colour to wall and other places when necessary two coats over a coat of primer including cleaning, sand papering the surface all complete as per direction of the EIC. |
200.00 |
M2 |
90.00 |
18,000.00 |
10 |
Industrial enamel painting of best quality and approved colour over the surface of f
acial , gutter , angle etc . two coats over a coat of primer including cleaning, sand papering the s
urface all complete as per direction of the EIC.(including supply of all materials)
|
200.00 |
M2 |
92.00 |
18,400.00 |
11 |
Epoxy painting (berger or equivalent) of best quality and approved colour to wall two coats over a coat of primer including cleaning, sand papering the surface all complete as per direction of the EIC.(including supply of all materials) |
1600.00 |
M2 |
245.00 |
392,000.00 |
12 |
Supplying , fitting and fixing homogeneous non-slip floor tiles( local made) including nosing of approved size and sample in stair where necessary with 20 mm thick cement sand mortar (1:3) all complete including skirting as per direction of the EIC. |
150.00 |
M2 |
815.00 |
122,250.00 |
13 |
Supplying, fitting and fixing of non-exposed grid type with G.P sheet screwup
suspended plaster board ceiling as per approved sample and drawing including all fittings , accessories make provisions for opening as per direction of the EIC.(Grid 600x1200mm)
|
250.00 |
M2 |
550.00 |
137,500.00 |
14 |
Supplying, fitting and fixing of non - exposed fixed screw up suspended plaster board ceiling with aluminium T-bar , filling the joints with thin cotton properly as per approved sample and drawing including all fittings , accessories make provisions for opening as per direction of the EIC . |
350.00 |
M2 |
1400.00 |
490,000.00 |
15 |
Epoxy painting (berger or equivalent) of best quality and approved colour to plastered board ceiling two coats over a coat of primer including cleaning, joint filling with cloths all complete as per direction of the EIC. (including supply of all materials) |
350.00 |
M2 |
245.00 |
85,750.00 |
16 |
Aluminium partition wall with clear glass, H=2400 mm |
39.00 |
M2 |
2600.00 |
101,400.00 |
17 |
Supplying , fitting and fixing of Aluminium swing doors with fixed partition as per U.S AAMA standard specification having 1.8 mm thick wall frame (size 101.6mm , 40 mm )1.8 mm thick shutter sides (size 50 mm , 40 mm ) , 0.49 mm thick door glass bit (size 16.54 mm , 14.49 mm ) , 2.5 mm thick closure section (size 101.6 mm , 40 mm) 2.3 mm to 4 mm thick handle (size 101.6 mm , 38.1 mm ) sections all aluminium members of pre approved manufacturer of powder coated white colour including all accessories , supplying and fitting 5 mm thick w
hite clear glass with neoprene , sealent all complete as per direction of the EIC.
Half plastic panel + half clear glass |
71.00 |
M2 |
5500.00 |
390,500.00 |
18 |
Supplying , fitting and fixing of Aluminium sliding / fixed window as per U.S AAMA standard specification having 1.2 mm thick outer bottom , top and sides (size 45 mm , 45 mm) all aluminum members of pre approved manufacturer of anodized silver colour including all accessories , supplying and fitting 5 mm thick white clear glass with neoprene , sealent all complete as per direction of the EIC. |
8.00 |
M2 |
4000.00 |
32,000.00 |
19 |
Supplying, fitting and fixing of motorized rolling shutter made of 24 SWG GP sheet unit minimum 69mm width having 10mm ans 12mm dia circular folding at ends, rolled in machine, locked togeteher properly to form rolling shutter, top of the shutter to be fitted with circular spring box made of 22 bwg sheet, containing best quality spring made of China, including alluminium switch box circuit breaker all complete as per direction of the EIC. |
17.00 |
M2 |
8300.00 |
141,100.00 |
23 |
Supplying , fitting & fixing of anodized aluminium coving as per approved sample with the ceiling and wall including all accessories such as screws , revit , gasket , sealent all complete as per direction of the EIC . |
280.00 |
RM |
365.00 |
102,200.00 |
24A |
Weather coat painting of best quality & approved colour to outside walls and other places where necessary over a coat of primer after cleaning, sand papering the surface as per manufacturer,s specification all complete as per direction of the EIC. |
0.00 |
M2 |
95.00 |
0.00 |
24B |
Painter Supply for Roofing Compound |
0.00 |
NOS. |
300.00 |
0.00 |
24C |
50 mm dia PVC Pipe Supply and fitting |
0.00 |
RM |
100.00 |
0.00 |
24D |
Electrical Conduit Groove Cutting |
1.00 |
RM |
140.00 |
140.00 |
24E |
Box Cutting for Electrical Switch (100x125x75mm) |
0.00 |
NO. |
150.00 |
0.00 |
24F |
Roof Punch for Electric and A/C line (100x100mm). |
0.00 |
NO. |
500.00 |
0.00 |
24G |
Wall Punch and Drilling (100x100mm)
|
0.00 |
NO. |
150.00 |
0.00 |
24H |
Wall Punch (200x100mm) |
0.00 |
NO. |
200.00 |
0.00 |
24I |
RCC Beam Punch (150x100x385mm). |
0.00 |
NO. |
300.00 |
0.00 |
24J |
RCC Drain Slab remove and refixing with drilling |
0.00 |
NO. |
200.00 |
0.00 |
24K |
CC Ramp Dismatling |
0.00 |
M2 |
50.00 |
0.00 |
24L |
Plaster Dismantling |
0.00 |
M2 |
60.00 |
0.00 |
|
|
|
|
Total: |
3,167,540.00 |